HO EMD FL9 Support Page
HO Scale EMD FL9 Support Page
Important DC Advisory
Do NOT use MRC 1300-series DC controllers with any of Rapido’s locomotives. The RailPower 1300 is notorious for voltage spikes and it WILL destroy your locomotive. There is no “if” about it. We will try to help you if we have the parts, but we are not responsible for locomotive damage due to voltage spikes in your power supply. As well, we will not repair any locomotive damaged by an MRC 1300-series controller (or any other “train set” DC controller) unless you have retired the controller. Otherwise the damage will soon reoccur. “Train set” DC controllers should not be used with any modern model locomotives.
General Problems and Inquiries
If your model arrives with damage or there is any other issue, the best thing to do is to contact our support team. They take care of all of our warranty repairs and they are all swell guys. The toll-free number is 1-855-LRC-6917 (1-855-572-6917) (outside North America, +1 905-474-3314 or 905-474-3324). You can also email us – click here.
DCC Decoder Installation
Our DC FL9s are DCC-ready and come equipped with a 21-MTC plug for easy DCC decoder installation.
Function Issues on Digitrax Systems
If you operate with a Digitrax DCC system and your DCC loco does not seem to be responding as it should, please try the fix described below before contacting us. It may save you some time and aggravation!
Apparently, some Digitrax systems store the address of every single loco that they’ve ever used on them, and regardless of whether the loco was dispatched or not. Once this memory fills up, any new locos that attempt to be used by that system exhibit very unusual behavior including non-working functions and odd responses.
The solution to this is easy. All you need to do is clear the memory in your system. This is done by clearing slot #36; see the instructions below. Once you’ve done this, you’ll likely find that your loco operates exactly as you expected it should.
General Instructions for Closing Command Station Option Switches (for specific instructions for your command station and throttle, see the instruction manual for your equipment):
- On the command station, set the MODE toggle switch to the OP (center) position.
- Using your throttle go into Switch Mode
- Enter the Option Switch number you wish to change (in this case 36).
- Press the “c” key on the throttle.
- You will hear a beep.
- On the command station move the MODE toggle down to SLEEP then back up to RUN.
- Using your throttle, turn Track Status back on.
For more information, see this page from Digitrax’s web site.
FL9 Parts Diagram
FL9 Exploded parts diagram
EMD FL9 ESU Non-sound LokPilot File
Click here to download. File is configured for a LokPilot V4.0 DCC. 54615
We are aware of an issue where the light baffle inside the locomotive shell can damage the LEDs on the locomotive’s light board. This is most commonly seen as one, or both, of the number boards failing to light.
If this is the case with your locomotive, please contact us and we will supply you with a replacement light board or arrange for your locomotive to be repaired.
Please note that a small amount of material must be removed from the light baffle inside the shell to accommodate the replacement light board.